Analog bypass

Analog bypass is a feature where the incoming video routed directly to output, sync is still cleaned and separated into H/V if the source is C-SYNC.

You can change this by editing the [base] section of the ini file:

[base]
bypass=auto

The individual settings are described below.

auto

This is the default setting, and routes the input signal directly to output when input frequency is higher than about 25kHz. 

The intended use is if you want to keep the scaler permanently attached to a monitor, but don’t want it do anything for video sources your monitor can handle natively.

off

Bypass feature is disabled

on

This is a special case that turns the scaler into a very expensive sync cleaner.

Last Updated on 2022-08-18 by admin